Tape Recorder Lab
Explore recording, magnetic memory and head alignment. Each workspace keeps its controls beside the results. To measure your own recorder – speed, wow and flutter, azimuth, bias and response – see Tape recorder.
Source → tape output
Tape transport · three heads
The colored patch represents one recorded event traveling from the record head to the reproduce head. Head spacing is illustrative: 34 mm.
Magnetic recording under a magnifier
Magnetic viewer · recorded pattern
How a tape patch remembers a signal
A separate, slowed-down demonstration. Adjust the bias and the local audio sample below.
Follow one small patch of tape
Horizontal H: applied magnetic field. Vertical M: magnetization retained by the tape. White dot: current state.
Playback-head azimuth · L/R timing
A tilted head gap reaches the two stereo tracks at different positions along the tape. Compare their reproduced test tones and convert the offset into microseconds.
Gap angle is enlarged in the sketch. The calculation uses the actual angle shown above.
Two channel waveforms and measured delay
How phase becomes a time offset
Geometry: Δx = s tan α; Δt = Δx / v; phase = 360° f Δt. To measure it, extract the L and R tone phases from short audio blocks and calculate Δt = −arg(R · L*) / (2πf). Repeat over time and average stable readings. A single tone only reveals delay within half a period (±50 µs at 10 kHz), so start low and refine at 10 kHz.
Reference tape and record → reproduce measurements
A reference tape checks the playback head against a known recording. After that, recording a test tone and switching to the reproduce head checks the record head against the aligned playback head. The L/R timing graph above models one playback-head angle; switching measurement methods alone would not change it.
L/R time difference measured in µs
Each point is the delay inferred from one 100 ms test-tone block. Zero means the channels have equal phase at that tone; one tone can hide a whole-period delay. The green ±2 µs band is the target AudioLab sets for the mean when adjusting the azimuth (Tape recorder), not a hard limit on every point.
Default 5 µs is an illustrative, realistic order of magnitude for tape skew variation. It changes L/R timing, not wow/flutter or simple up-and-down tape translation.
How rotating parts create speed variation
Choose a source, then compare tape speed in time with the spectral lines predicted from component size.
Tape path and rotating parts
Speed variation over time
Positive values mean faster tape; negative values mean slower tape. The trace sums the selected periodic speed errors.
Spectrum of speed variation
Simulator notes: The colored bands show magnetization direction, not a ridge on the tape. Bias and hysteresis are qualitative simulations, not calibration targets.